Figure 3–57: Needle tip in needle guide
Needle guide
Needle tip
10. Allow the water and deposits to drip off the needle, and then carefully remove the wipe
from beneath the needle.
11. Reinstall the access panel and use the T20 TORX driver to tighten the two screws that
secure the panel to the front of the unit.
Requirement:
Ensure that the seal-port tube and sample-needle tubing are routed
through the gap in the access panel.
Figure 3–58: Tubing routed through access panel gap
1
2
3
1
2
June 11, 2019, 715005051 Rev. D
Page 103