Sm-Ftn And Biosm-Ftn Input/Output Specifications; Sm-Ftn And Biosm-Ftn Performance Specifications - Waters ACQUITY UPLC Overview And Maintenance Manual

Sample manager flow through needle
Table of Contents

Advertisement

Attribute
Overvoltage category
Pollution degree
Moisture protection
Line voltages, nominal
Voltage range
Frequency
Maximum power draw
a. Protection Class I – The insulating scheme used in the instrument to protect from electrical shock. Class I identifies a single
level of insulation between live parts (wires) and exposed conductive parts (metal panels), in which the exposed conductive
parts are connected to a grounding system. In turn, this grounding system is connected to the third pin (ground pin) on the
electrical power cord plug.
b. Overvoltage Category II – Pertains to instruments that receive their electrical power from a local level such as an electrical
wall outlet.
c.
Pollution Degree 2 – A measure of pollution on electrical circuits that can produce a reduction of dielectric strength or
surface resistivity. Degree 2 refers only to normally nonconductive pollution. Occasionally, however, expect a temporary
conductivity caused by condensation.
d. Moisture Protection – Normal (IPX0) – IPX0 means that no Ingress Protection against any type of dripping or sprayed water
exists. The "X" is a placeholder that identifies protection against dust, if applicable.
B.4 SM-FTN and bioSM-FTN input/output specifications
Attribute
Event output relay (Inject Start Out)
Digital input signal (Inject Hold In)
B.5 SM-FTN and bioSM-FTN performance specifications
Item
Injection volume
range
b
c
d
Specification
• With the standard loop fitted, 0.1 to 10.0 µL, in 0.1 µL increments.
• With one of the optional extension loops fitted, as much as the volume
of the extension loop (50, 100, 250, or 1000 µL).
June 11, 2019, 715005051 Rev. D
Specification
II
2
Normal (IPXO)
Grounded AC
100 to 240 Vac
50 to 60 Hz
400 VA
Specification
Maximum current: 0.5 A
Maximum input voltage: 30 Vdc
Contact resistance: 0.2 ohms
Maximum input voltage: 30 Vdc
Logic high: 3.0 Vdc
Logic low: 1.9 Vdc
Page 120

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents