Stacking System Modules With Interlocking Features - Waters ACQUITY UPLC Overview And Maintenance Manual

Feet on underside of module being stacked
Indents on top side of previously added module
2. Carefully lower the module so that the feet rest in the indents.
Important:
ensure that the feet of the upper module rest in the indents of the lower module.
3. Repeat steps 1 and 2 for the remaining system modules.

2.4 Stacking system modules with interlocking features

This procedure applies to system modules equipped with interlocking features.
Warning:
without assistance.
Warning:
care when installing a module in the system stack.
Warning:
higher than one meter (39.4 inches) above the bench top.
To stack the modules:
1. Place the rear feet of the module that you are adding atop the previously added module in
the system stack, and slide it backward until its rear alignment pin rests in the rear
alignment slot on the previously added module.
Figure 2–3: Aligning pins with slots
To maintain the integrity of the system stack and integrated waste system,
To avoid spinal and muscular injury, do not attempt to lift a system module
To avoid crushing your fingers beneath or between modules, use extreme
To avoid injury, do not stack modules, including the solvent tray and rails,
June 11, 2019, 715005051 Rev. D
Page 27