Reinstalled tightening
2.2 Ventilation requirements
Allow at least 15.2 cm (6.0 inches) clearance at the rear, and at least 6.4 cm (2.5 inches)
clearance on the right-hand side of the sample manager for ventilation.
2.3 Stacking system modules without interlocking features
This procedure applies to system modules that are not equipped with interlocking features.
Warning:
without assistance.
Warning:
care when installing a module in the system stack.
To stack the modules:
1.
Align the front and rear feet of the module that you are adding with the corresponding
indents in the top of the chassis of the previously added module in the system stack.
Figure 2–2: Aligning feet with indents
To avoid spinal and muscular injury, do not attempt to lift a system module
To avoid crushing your fingers beneath or between modules, use extreme
June 11, 2019, 715005051 Rev. D
Page 26