Chapter 3 Replacing Assemblies
Removing the Front Panel Assembly
Figure 3-4. Removing the Shroud
Removing the Front Panel Assembly
Use the following procedure to remove the front panel assembly:
1
Remove the shroud (see "Removing the Shroud" on page 3-7).
2
Use a 5/16-inch wrench to loosen the nut that attaches the Power Meter
output cable to the back of the Power Meter OUTPUT connector on the
front panel assembly.
3
Disconnect the Power Meter output cable from the back of the Power
Meter OUTPUT connector.
3-8
Assembly Level Service Guide