Agilent Technologies 53147A Assembly Level Service Manual page 128

6
7
8
NOTE
9
10
Appendix A Rack Mounting the Instrument
Rack Mounting the Instrument
Insert the eight 3/8-inch x 4-40, pan-head Phillips screws (2) supplied in
the Rack Mount Kit through the holes in the top and bottom of the rack-
mount panel into the threaded holes in the top and bottom of the
instrument. Start the screws, but do not tighten them at this time.
1
Insert the six 10mm long, 4 mm x .7, pan-head Torx screws (1) supplied in
the Rack Mount Kit through the holes in the side flanges of the rack-
mount panel and tighten them fully.
Tighten the eight screws you inserted in Step 6.
You can use angle brackets to help support the instrument in the rack and
to make it easier to mount the instrument.
Place the four Nylon washers supplied in the Rack Mount Kit over the
four 10-32 screws (3, 4).
Inspect the holes in the rack to determine if they are threaded. If the holes
are threaded, skip Step 11.
A-4
2
2
3, 4
Assembly Level Service Guide
1
3, 4