Agilent Technologies 53147A Assembly Level Service Manual page 129

Appendix A Rack Mounting the Instrument
Rack Mounting the Instrument
11 Insert the four sheet-metal U-nuts provided in the Rack Mount Kit in the
rack flange behind the four holes you intend to use to mount the instrument.
12 While holding the instrument in position in the rack, insert one of the
10-32 screws with the Nylon washer on it (3,4) through one of the upper
holes in the rack-mount panel into the threaded hole in the rack (or into
the U-nut you installed in Step 11 if the hole is not threaded).
13 Repeat the procedure in Step 12 for the remaining upper rack-mount hole
and the two lower rack-mount holes.
14 Tighten all four rack-mount screws.
15 Connect the power cord to the Main
instrument's rear panel.
16 Connect the other end of the power cord to an appropriate AC power source.
Assembly Level Service Guide
~
Power input connector on the
A-5