Agilent Technologies 53147A Assembly Level Service Manual page 48

12
CAUTION
13
NOTE
14
15
16
17
NOTE
18
Chapter 1 Performance Tests
Test 5: Power Meter Reference Level
Set the Digital Multimeter to measure microvolts.
Ensure that the Agilent 34401A Digital Multimeter's input leads are
isolated from chassis ground before performing the next step.
Connect the positive test prod from the Agilent 34401A Multimeter to
the V connector on the Agilent 432A Power Meter rear panel.
COMP
The V and V connectors are BNC female. You can use two BNC-to-
COMP RF
banana jack adapters and two BNC cables to make it easier to connect the
Multimeter to the Power Meter.
Connect the negative test prod from the Agilent 34401A Digital
Multimeter to the V
RF
If the reading on the Multimeter is less than 400 microvolts, proceed to
step 16. If the reading is 400 microvolts or more, press the FINE ZERO
toggle switch on the 432A Power Meter's front panel down.
Observe the reading on the Multimeter, round off the reading to the
nearest microvolt, and keep a record of this value as V
Turn on the Agilent 53147A/148A/149A's internal power reference
oscillator:
Press Shift + Menu, use the up and/or down arrow keys to cycle through
the menu to PWR REF, press the right-arrow key, then use the up or down
arrow key to change the setting to ON, and press the Enter key. The Pwr
Ref annunciator should now be activated.
The reference oscillator is normally off. It is turned on automatically
during calibration and then turned back off when calibration is complete.
When PWR REF in the 53147A/148A/149A's menu is set to ON, the power
reference oscillator is turned on, and it is left on after calibration.
Observe the reading on the Multimeter, and keep a record of this value
as V .
1
1-36
connector on the 432A Power Meter's rear panel.
Assembly Level Service Guide
.
0