Table of Contents
Advertisement
7.6 Depreservation and represervation
Depreservation method is chosen depending on preservation materials used. Sur-
faces under preservation have to be wiped with cleaning cloth soaked with low-viscous
oils, solvents, or washed away with washing water-soluble detergents. Sealed assembles
should be stripped off insulation materials (film, paper). Inside surfaces under preservation
need no depreservation.
Tractor represervation is carried out in case conservation defects are detected in
the process of storage or upon expiration of protection life.
7.7 Putting tractor into operation after long-term storage
Perform depreservation of an engine according to the engine operation manual.
Remove grease off external surfaces under preservation. Dismount protective co-
vers, plugs, special accessories and mount the parts which were removed earlier back in
their places. Before mounting parts clean them off grease and dust. Drain sediment out of
all vessels, fill them with operation fluids and, if necessary, top up to control level.
Lubricate all tractor mechanisms according to point 3 of Table 5.4 of the present
operation manual. Carry out scheduled maintenance. Run tractor for 15-20 minutes. Cor-
rect detected faults if necessary.
7.8 Safety requirements for preservation
The preservation procedure, comprising surfaces preparation, coating with preser-
vation materials, paper marking and cutting, packing, shall be carried out only by persons
of the age, subjected to medical examination, properly instructed on labor and fire safety,
and receiving primary instructions on the working place. Preservation remises and sec-
tions should be separated from other production premises and equipped with plenum-
exhaust ventilation. Materials used for preservation are combustible substances with flash
temperature from 170 to 270
cations and have quality certificate.
Conservation materials being supplied should bear label with material description.
Perform preservation operations in special clothes and footwear and use individual protec-
tion means. When performing preservation operations, observe personal hygiene rules,
dry clean special clothes in time, don't wash it in emulsions, solvents, kerosine. By the de-
gree of impact on human health, preservation materials are classified as of moderate haz-
ard, so use recommended individual protection means while handling materials.
With prolonged exposure of skin to preservation oils, greases and liquids, it may be
injured. White spirit vapors in small concentrations act as weak drug, large concentration
may result in poisoning. Anticorrosion paper contains corrosion inhibitors causing irritation
and inflammation of skin, mucous of nose and eyes. Before starting work put on cotton
overalls, robe or apron, prepare individual protection means depending on work conditions
and toxicity of substances used. Grease hands with protection paste (cream) and put on
cotton and rubber gloves. Before starting work, safe conditions of which are not known,
claim for safety inductions.
8. TRACTOR TRANSPORTATION AND TOWING
8.1 Tractor transportation
Tractors are transported by railroad, motor vehicles or under its own power.
Engage the parking brake and the first gear of the gearbox for tractor transportation.
Fasten BELARUS-1025.6 tractor to the rail platform with four sling ropes.
Fasten one sling rope on each side to a special nut located on rear wheel hub by one
end, and to binder bracket by another end. Also fasten one sling rope on each side of the trac-
tor to the special front wheel nut by one rope end and to binder bracket by another end.
o
C, and should comply with state standards, technical specifi-
173
1025.6-0000010 OM
Advertisement
Table of Contents
