Power Supply Unit; Removing The Power Supply Unit Blank - Dell EMC PowerEdge T340 DPJ1G Installation And Service Manual

Figure 69. Installing the heat sink
Next steps
1 Replace the air shroud.
2 Follow the procedure listed in
3 While booting, press F2 to enter System Setup and verify that the processor information matches the new system configuration.
4 Run the system diagnostics to verify that the new processor operates correctly.

Power supply unit

NOTE: For more information, see the

Removing the power supply unit blank

Prerequisite
1 Follow the safety guidelines listed in
Step
Remove the PSU blank in the bay by pulling the blank outward.
96 Installing and removing system components
After working inside your system.
Technical specifications
Safety instructions.
section.