Diffusor Blue Loop; Rgby Converging Lenses; Converging Lens (Entrance) - Barco F90 Service Manual

2. 2. Remove the clip holding lens in place.
3. 3. Lift out the lens.
Note: The Blue Loop lense 4 is NOT directional.
Image 22-11

22.2.8 Diffusor blue loop

1. 1. Use the wedges to gently pull out the diffusor.
Image 22-12

22.2.9 390 RGBY Converging Lenses

Each TI Loop is equipped with 2 Converging Lenses, one at the entrance and one at the exit of the loop.
• Always use finger cots or gloves when handling lens elements
• NOTE direction of lens when reinstalled. The flat surface should be facing outwards towards Laser cluster, curved/concave
side in.
• NOTE direction of clip when mounting. The four (4) center flaps should point inwards.

22.2.9.1 Converging Lens (Entrance)

1. Place a cloth or similar on the entrance floor to protect the lens in case it falls when screws/clips is released.
2. Remove 4 screws (Tx8 M2.5x6) releasing the clip and lens.
3. Assemble in reverse order.
Image 22-13
723–0016 F90 01/12/2017
Image 22-14
22. TI Loop
Image 22-15
115