Pcb Inlet Temp Sensor Board No1; Pcb Inlet Temp Sensor Board No2 - Barco F90 Service Manual

2. Slide the PCB IR out from cover and disconnect the cable from the PCB thermal Hub.
Note: The IR cover, including PCB IR, is held in place by the top cover once this is mounted.
Image 19-15

19.3.4 PCB Inlet temp sensor board No1.

1. This PCB is located on the frame radiator back.
2. Disconnect the cable and remove one screw (T8 M2,5x6)
Note: Do not touch components on the board directly during handling; always hold the board edges!
Image 19-16

19.3.5 PCB Inlet temp sensor board No2.

1. This PCB is similar to the PCB inlet board, ref. 18.3.4, and located the back side of the radiator fans.
2. Disconnect the cable and remove one screw (T8 M2,5x6)
Note: Do not touch components on the board directly during handling; always hold the board edges!
723–0016 F90 01/12/2017
19. Disassembly / Assembly instructions
85