Frame Radiator Right Module - Barco F90 Service Manual

Image 20-37
2. Remove also 2 screws (Tx10 M3x8) securing left radiator frame to the housing bottom
3. Follow the same procedure as described in "Remove Frame Radiator Left Module", page 98, step 3 and forward.

20.3.5 Frame radiator right module

About
For ease of access to the cooling pump for the DMD, it may be easier to remove two laser driver boards and PCB Thermal hub
board first. These boards can be removed as one unit, mounted in the laser driver cage.
It is also possible to access the pumps without removing laser drivers, but that requires you have flexible hex tools.
It will be an advantage to loosen the pump modules as the first step, to minimize stress on the tubes for the cooling liquid. It may
sometimes happen that the spacer for the spring loaded screws detaches instead of the screw itself. This is not a problem in itself;
just bring it back in the same position during reassembly.
1. Remove 2 screws (Tx10 M4x8) securing frame radiator center to bracket.
2. Remove 1 screw (Tx10 M3x8) securing left radiator frame to the hosuing bottom.
3. Follow the same procedure as described in "Remove Frame Radiator Left Module", page 98, step 3 and forward.
Image 20-38
723–0016 F90 01/12/2017
Image 20-39
20. Scheduled operations
99