Ti Loop; General - Barco F90 Service Manual

22. TI LOOP

All dove clamp screws shall be tighten with a torque of 3,1Nm.
All screws fastening the clusters and interface to the base plate shall be tighten with a torque of 1,5Nm.

22.1 General

W
ARNING
dling of the components inside the module.
Use rubber finger cots while handling optical components to avoid staining or otherwise damaging optical coating. Imprints from the
unprotected fingers will cause overheating and damage of optical components.
Left and right TI Loops are identical modules. But the right module is turned upside down related to the left module, in order to fit to
the engine assembly.
• Service within the TI loop for left channel can be done by removing the Top cover following the below instructions.
• In order to do service inside TI loop for right channel, the entire compartment needs to be disconnected from base plate and
removed from the complete engine. Beyond this, the procedures for service and repair of the modules are equal.
Image 22-1
723–0016 F90 01/12/2017
:
The TI loops modules are critical components, both with regards to laser safety and proper han-
TI Loop left TI Loop left TI Loop right TI Loop right
22. TI Loop
111