Removing Peripheral"Mini" Pcb's; Pcb Gp6 Ir Receiver And Led Board Top; Pcb Front Usb & Trigger Board; Pcb Ir Front - Barco F90 Service Manual

19. Disassembly / Assembly instructions
Image 19-11

19.3 Removing peripheral"mini" PCB's

19.3.1 PCB GP6 IR Receiver and LED Board TOP

IR Receiver
1. Remove 2 screws (TX8 PT25x8) securing the PCB IR Receiver board to top cover. Lift up the PCB. The LED lens can now also
be removed. When reassembling, be sure to position the tabs in an upwards position, as indicated by the red arrow.
Image 19-12
19.3.2 PCB Front USB & Trigger board
USB
1. Remove 2 screws (Tx10 M3X6) and release the USB PCB from the metal USB bracket.
Note: For information: The bracket is secured to the Cover Left with two screws (TX10 M3x8).
Image 19-14

19.3.3 PCB IR Front

1. Pull the IR Cover incl. PCB IR up and out of the holder.
84
Location of
IR receiver board
Image 19-13
IR receiver assembly
Observe the tab
723–0016 F90 01/12/2017