Remove The Side Cover Left; Remove The Side Cover Right - Barco F90 Service Manual

Image 19-8
5. Then the top cover can be removed by gently pry the cover upwards.

19.2.4 Remove the Side cover left

1. Remove 2 pcs Tx10 M3x8 screws on the front end of the left side panel, in order to release the Front USB and Trigger board
from the side panel. Indicated by the blue circles.
Image 19-9
2. Remove the 3 screws Tx20 M4x10 indicated by the red circles, and gently move the panel a bit out, and disconnect the two cable
from the PCB
Note: Caution must be exercised when the cover is removed due to the two cables that still are connected to the pcb on the
inside of the side cover.
3. Disconnect the Flex Cable from the Back Panel PCB by gently lifting up the tab on the connector and remove cable from the
connector. This is sensible components – do not use high forces for this procedure.
Note: Be careful with flex cable and locks. They are fragile components.
Image 19-10
Principle of flex cable locking mechanism. Flip lock connector.
4. 5. Disconnect the second cable.
5. 6. Carefully remove the side panel from the unit.

19.2.5 Remove the Side cover right

1. 1. Remove M4x10 screws on the right side indicated with red circles. Use a TX20 screwdriver. Carefully lift out the right cover.
723–0016 F90 01/12/2017
19. Disassembly / Assembly instructions
83