Table of Contents
Advertisement
Error! Reference source not found. Error! Reference source not found.
4 - 1 5
Step 10: When you reach the Update PLC screen, press F3 (ENTER).
Step 11: Press F3 to restore data from memory card to the display (text and icons).
Step 12: The registers will then be restored from the memory card to the display.
Step 13: Press F4 (OK).
Step 14: Turn off power to bar feeder.
QUICK LOAD SERVO S3
Advertisement
Table of Contents
Need help?
Do you have a question about the QUICK LOAD SERVO S3 and is the answer not in the manual?
Questions and answers
LNS BARFEEDER sps no response , how do i fix this error
The SPS No Response alarm on the QUICK LOAD SERVO S3 occurs due to a communication problem between the remote control station and the LNS PLC. To fix this error:
1. Check the connectors between the PLC and the remote control station inside the cross piece to ensure they are correctly attached.
2. Verify continuity between the PLC and the remote control station.
These steps help restore proper communication and resolve the error.
This answer is automatically generated