A048 - Safety Time For Part Feed Out Elapsed - LNS QUICK LOAD SERVO S3 Troubleshooting And Spare Parts Manual

Chapter 1: Alarms
A048 – Safety Time for Part Feed Out Elapsed
SAFETY TIME
FOR PART FEED OUT
ELAPSED!
POSSIBLE CAUSES:
-PROGRAMMING ERROR
-MECH. INTERFERENCE
-INTERFACE PROBLEM
Description:
The Safety Time For Part Feed Out Elapsed alarm occurs if the value set in OVERALL PART LENGTH is not reached within 1 minute
after the bar feed is commanded to feed out.
Solution:
Case Application
Feed out with turret and
1
with m-code
Feed out with turret and
2
without m-code
Feed out without turret
3
and with m-code
Feed out without turret
4
and without m-code
Contact LNS America, Inc. for further information.
A048
•
Check that the position of the turret is correct for
the length of the part feed.
•
Check for mechanical obstacle preventing the bar
from completing the feed out.
Alarm needs to be cleared. Press the STOP key on the
remote control station to clear the message and reset
the alarm.
•
Check that the position of the turret is correct for
the length of the part feed.
•
Check for mechanical obstacle preventing the bar
from completing the feed out.
Alarm needs to be cleared. Press the STOP key on the
remote control station to clear the message and reset
the alarm.
•
Check for mechanical obstacle preventing the bar
from completing the feed out.
Alarm needs to be cleared. Press the STOP key on the
remote control station to clear the message and reset
the alarm.
•
Check for mechanical obstacle preventing the bar
from completing the feed out.
Alarm needs to be cleared. Press the STOP key on the
remote control station to clear the message and reset
the alarm.
Solution
QUICK LOAD SERVO S3
1 - 1 7