Servo Motor Following Error During Sequence 12 - LNS QUICK LOAD SERVO S3 Troubleshooting And Spare Parts Manual

Hide thumbs Also See for QUICK LOAD SERVO S3:
Table of Contents

Advertisement

2 - 4

Servo Motor Following Error During Sequence 12

SERVO MOTOR
POSITIONING
FOLLOWING ERROR!
DURNG SEQUENCE
NUMBER [12]
POSSIBLE CAUSE:
MECHANICAL OBSTACLE
PREVENTS BAR STOCK
TO FEED OUT
Description:
The Servo Motor Following Error! During Sequence Number [12] alarm occurs after the new bar has been measured and is being
advanced to top-cut position. The torque on the servo motor will build up when an obstacle prohibits the stock from moving, once the
torque reaches a certain limit the PLC instructs the servo amplifier to quit pushing and this alarm message appears on the remote
control station.
Solution:
Cause
Hitting back of spindle
Hitting back of
clamping system
QUICK LOAD SERVO S3
• Check that the correct bar stock diameter is entered for the parameter.
• Check that the correct spindle reduction tube is installed.
• Verify the alignment of the bar feeder. If the alignment is off; realign and
then recalibrate the loading table, refer to
Calibration of the Loading Table pg.
• Verify the correct collet/chuck is installed for the material being run.
Chapter 2:
Solution
Alignment Procedure pg. 3-3
3-31.
Common Issues
and

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the QUICK LOAD SERVO S3 and is the answer not in the manual?

Questions and answers

tom,
March 18, 2025

LNS BARFEEDER sps no response , how do i fix this error

1 comments:
Mr. Anderson
March 18, 2025

The SPS No Response alarm on the QUICK LOAD SERVO S3 occurs due to a communication problem between the remote control station and the LNS PLC. To fix this error:

1. Check the connectors between the PLC and the remote control station inside the cross piece to ensure they are correctly attached.
2. Verify continuity between the PLC and the remote control station.

These steps help restore proper communication and resolve the error.

This answer is automatically generated

Subscribe to Our Youtube Channel

Table of Contents

Save PDF