Safety Instructions And Warnings - NETGEAR GS728TXPv3 Hardware Installation Manual

24-Port and 48-Port Gigabit Ethernet PoE+ Smart Switches with 4 SFP Ports or 4 10G SFP+ Ports
○ IEEE 802.3af Power over Ethernet (PoE)
○ IEEE 802.3at Power over Ethernet plus (PoE+)
• AutoSensing and autonegotiating capabilities for all ports.
• Auto Uplink™ technology is supported on all ports.
• Automatic address learning function to build the packet-forwarding information
table. The table contains up to 16K Media Access Control (MAC) addresses.
• Store-and-forward transmission to remove bad packets from the network.
• Active flow control to minimize packet loss and frame drops.
• Half-duplex backpressure control.
• Per-port status LEDs and system status LEDs.
• NETGEAR green power-saving features:
Energy efficiency mode that fully conforms to the IEEE802.3az standard
○
○ Per-port automatic change to a lower power mode when the port link is down

Safety instructions and warnings

Use the following safety guidelines to ensure your own personal safety and to help
protect your system from potential damage.
To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment,
observe the following precautions:
• This product is designed for indoor use only in a temperature-controlled and
humidity-controlled environment.
Note the following:
○ For more information about the environment in which this product must operate,
see the environmental specifications in the appendix or the data sheet.
○ If you want to connect the product to a device located outdoors, the outdoor
device must be properly grounded and surge protected, and you must install an
Ethernet surge protector inline between the indoor product and the outdoor
device. Failure to do so can damage the product.
WARNING:
see https://kb.netgear.com/000057103 for additional safety and warranty
information.
Introduction
Before connecting the product to outdoor cables or devices,
10 Hardware Installation Guide