Replacing The Zero Point Filter - Swann AMI Turbitrace Operator's Manual

AMI Turbitrace
Maintenance
Check O-ring
6.4.
A-96.250.131 / 050220
6 Screw the screw cover with the new humidity absorber flask into
the measuring cell.
7 Tighten it well.
NOTICE: After replacing the humidity absorber, the dew point
decreases only slowly. It may take several days until the dew
point is below 3 °C again.
When replacing the humidity absorber, also check the bayonet lock
cover for leaks.
1 Remove the bayonet lock cover and check the O-ring for
damage.
2 Replace the O-ring if it is damaged.

Replacing the Zero Point Filter

A B
A
Filter cover
B
Zero point filter
39