Swann AMI Turbitrace Operator's Manual page 60

AMI Turbitrace
Program List and Explanations
3.2.2.41
3.2.2.1
3.2.2.2
3.2.2.3
3.2.2.42
3.2.2.42.1
3.2.2.42.2
3.2.2.42.8
5.3.2.1
5.3.2.1
5.3.2.1
3.30 Simulation
58
Start time: The start time can be set daily at any time of a day with
the [ ] or [
Range: 00:00:00–23:59:59
Mode weekly, details see
Method: see Mode interval,
Run time: see Mode interval,
Calendar:
Start time: The programmed start time is valid for each of the pro-
grammed days. To set the start time, see
Monday: Possible settings, on or off
to
Sunday: Possible settings, on or off
Mode off
The automatic calibration is switched off.
Mode Input
The calibration can be started via an external PLC connected to the
input of the AMI Transmitter.
Mode Fieldbus
The calibration can be started via Fieldbus connected to the AMI
Transmitter.
To simulate a value or a relay state, select the
 alarm relay,
 relay 1 and 2
 signal output 1 and 2
with the [ ] or [
Press the [Enter] key.
Change the value or state of the selected item with the [
[ ] key.
] key.
5.3.2.24, p. 67
3.2.2.1, p. 57
3.2.2.1, p. 57.
] key.
3.2.2.41, p. 58.
A-96.250.131 / 050220
] or