Table of Contents
Advertisement
AMI Turbitrace
Program List and Explanations
5.4.3
5.4.4
5.4.4.1
5.4.4.2
5.4.4.3
5.4.4.4
5.4.5
5.4.6
5.5 Interface
5.5.1
5.5.20
5.5.30
5.5.40
5.5.1
5.5.21
5.5.31
5.5.41
5.5.1
5.5.1
70
Load Firmware: Firmware updates should be done by instructed
service personnel only.
Load Firmware
no
yes
Password: Select a password different from 0000 to prevent unau-
thorized access to the following menus:
Messages
Maintenance
Operation
Installation.
Each menu may be protected by a different password.
If you forgot the passwords, contact the closest SWAN representative.
Sample ID: Identify the process value with any meaning full text,
such as KKS number.
Line Break Detection: Define if message E028 should be issued in
case of a line break on signal output 1 or 2.
Choose between <Yes> or <No>.
Select one of the following communication protocols. Depending on
your selection, different parameters must be defined.
Protocol: Profibus
Device address:
ID-Nr.:
Local operation:
Protocol: Modbus RTU
Device address:
Baud Rate:
Parity:
Protocol: USB-Stick
Only visible if an USB interface is installed. No further settings are
possible.
Protocol: HART
Device address:
Range: 0–126
Range: Analyzer; Manufacturer; Multivariable
Range: Enabled, Disabled
Range: 0–126
Range: 1200–115 200 Baud
Range: none, even, odd
Range: 0–63
A-96.250.131 / 050220
Advertisement
Table of Contents
