Table of Contents
Advertisement
AMI Turbitrace
Program List and Explanations
5.3.2.24
5.3.2.342
5.3.2.342.1
5.3.2.342.2
5.3.2.342.8
5.3.2.44
5.3.2.54
5.3.2.6
5.3.2.7
5.3.2.1
5.3.4
5.3.4.1
5.3.4.2
68
weekly
The relay contact can be activated at one or several days, of a
week. The daily starting time is valid for all days.
Calendar:
Start time: The programmed start time is valid for each of the pro-
grammed days. To set the start time see
Range: 00:00:00–23:59:59
Monday: Possible settings, on or off
to
Sunday: Possible settings, on or off
Run Time: see Interval
Delay: see Interval
Signal Outputs: see Interval
Output/Control: see Interval
Function = Fieldbus
The relay will be switched via the Profibus input. No further param-
eters are needed.
Input: The functions of the relays and signal outputs can be de-
fined depending on the position of the input contact, i.e. no function,
closed or open.
Active: Define when the input should be active:
Input is never active.
No:
When closed
Input is active if the input relay is closed
Input is active if the input relay is open
When open:
Signal Outputs: Select the operation mode of the signal outputs
when the relay is active:
Signal outputs continue to issue the measured
Continuous:
value.
Signal outputs hold the last valid measured value.
Hold:
Measurement is interrupted. Errors, except fatal
errors, are not issued.
Set to 0 or 4 mA respectively. Errors, except fatal
Off:
errors, are not issued.
5.3.2.341, p.
67.
A-96.250.131 / 050220
Advertisement
Table of Contents
