Auto Reset Shank And Shovel Installation - Landoll 2210 Operator's Manual

NOTE: DISC GANG CYLINDER IS FULLY RETRACTED.
16"
disc gang height
3-6.11 Connect the front gangs to the radius
rods with a 1-8 x 5-1/2 hex head cap screw.
Before tightening the front gangs, adjust the
gang height as shown in Figure 3-11 to 16"
from the bottom of the frame to the top of the
disc blades.
3-6.12 Once this dimension is set, tighten jam
nuts on the front radius rods.

3-7 AUTO RESET SHANK AND SHOVEL INSTALLATION

3-7.1 Attach each shank assembly to each
clamp assembly using 3/4-10 x 4 hex head
cap screws and hex lock nuts.
Figure 3-11 Disc Gang Height Adjustment
3-6.13 The rear radius rods are adjustable and
once installed with a 1-8 x 5-1/2 hex head
cap screw should be set to 14" from the bot-
tom of the frame to top of disc blade for ini-
tial operation.
3-7.2 Connect 2 x 1 x 18 spike to each shank
using 1/2-13 x 3 hex head cap screws, flat
washers, and heavy hex nuts (See Figure
3-10).
16"
3-17