Disc Blades - Landoll 2210 Operator's Manual

4-11 DISC BLADES

4-11.1 The 2210 Disc Chisel is equipped with
24" disc blades.
4-11.2 The 24" diameter blades are flat with a
thickness of 4 ga (.256") and are standard
for the 2210 Disc Chisel.
4-11.3 Sharpening – In some cases there is a
desire to sharpen disc blades for improved
cutting. There are several people who
roll-sharpen disc blades.
used today are made of chrome-boron steel.
The chrome-boron steel has a higher hard-
ness than traditional carbon-steel blades for
increased wear. Higher hardness makes roll
sharpening more difficult often with mixed re-
sults, and is not covered by warranty. Disc
blade manufacturers will not cover any alter-
ations to blades other than the place of man-
ufacture. Results from roll-sharpening dam-
age may not be immediate, and may take
more than a season to be noticeable. If you
choose to sharpen disc blades, check with
local dealers
sharpeners that will stand behind their work.
Most disc blades
for reputable experienced
DANGER
DISC BLADES ARE EXTREMELY
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR DISC
BLADES. DO NOT ALLOW DISC S TO
ROLL OVER OR FALL ONTO ANY
BODY PART. DO NOT ALLOW
WRENCHES TO SLIP WHEN WORKING
NEAR DISC BLADES. NEVER PUSH
WRENCHES TOWARD DISC BLADES.
DO NOT CLIMB OVER MACHINE
ABOVE DISC BLADES. FAILURE TO
STAY CLEAR OF DISC BLADE EDGES
CAN CAUSE SERIOUS PERSONAL IN-
JURY OR DEATH.
4-9