Disc Gang Installation - Landoll 2210 Operator's Manual

3-6 DISC GANG INSTALLATION

DANGER
DISC BLADES ARE EXTREMELY
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR DISC
BLADES. DO NOT ALLOW DISC TO
ROLL OVER OR FALL ONTO ANY
BODY PART. DO NOT ALLOW
WRENCHES TO SLIP WHEN WORKING
NEAR DISC BLADES. NEVER PUSH
WRENCHES TOWARD DISC BLADES.
DO NOT CLIMB OVER MACHINE
ABOVE DISC BLADES. FAILURE TO
STAY CLEAR OF DISC BLADE EDGES
CAN CAUSE SERIOUS PERSONAL IN-
JURY OR DEATH.
3-6.1 Assemble the disc gang lift to the frame.
Install the 4" UHMW bearings and bearing
caps using 3/4-10 x 2 hex head cap screws
and hex lock nuts (See Figure 3-6).
3-6.2 Install 4 x 8 hydraulic cylinder with rod
pointing up to the frame weldment using the
clevis pins and roll pins which come with
each cylinder.
3-6.3 Install 2- 90
cylinder.
Note: Assemble front gangs first to prevent
machine from tipping over backwards.
IMPORTANT
FOR PROPER OPERATION, THE 90
BOWS W/ RESTRICTORS MUST BE THE
SAME IN EACH END OF THE 4 X 8 HYDRAU-
LIC CYLINDER.
o
elbow w/ restrictor into the
o
EL-
3-13