Auto Reset Shank And Shovel Installation - Landoll 2131 Operator's Manual

ASSEMBLY INSTRUCTIONS
Auto Reset Shank and Shovel
Installation
1. Attach each shank assembly to each clamp
assembly using 3/4-10 x 5 hex head cap screw in the
top hole, 3/4-10 x 4 hex head cap screw in the
bottom hole, and hex lock nuts. Be sure that twisted
shovels are placed correctly (See Figures 2-1 thru
2-16.)
NOTE
For shallower depths, it may be necessary to move shank
into upper mounting holes. For certain conditions shank
may also be rotated forward when using twisted shovels.
3-14
2. Install 2 x 1 x 18 spikes or 1/2 x 4 x 26 twisted
shovels onto shanks as follows:
a. Connect 2 x 1 x 18 spike to each shank using
1/2-13 x 3 hex head cap screws, flat washers,
and heavy hex nuts (See Figure 3-8.).
b. Connect 1/2 x 4 x 26 twisted shovels to each
shank using 1/2-13 x 3 plow bolts, flat washers,
and heavy hex nuts. See Figures 2-1 thru 2-16
for proper locations of right hand and left
hand shovels.
IMPORTANT
Right and left twisted shovels are determined by
direction of dirt flow when facing the direction of
travel.
F-721-0513