Light Installation - Landoll 2210 Operator's Manual

3-10 LIGHT INSTALLATION

Note: See Figures 2-1 - 2-2 for light bracket
placement. If no dimension is given for a
bracket, it should be located against frame
member as shown in drawing.
3-10.1 Attach inner tail light mounting bracket
supports to the center frames using 1/2-13 x
8-1/2 hex head cap screws, warning light
bars, and hex lock nuts (See Figure 3-17).
3-10.2 Attach outer LH and RH light brackets
to frame weldment using 1/2-13 x 7-1/2 hex
head cap screws, warning light bars, and hex
lock nuts.
3-10.3 Attach red brake lamps to inner tail light
mounting bracket supports and amber lamps
to outer light brackets using 1/4-20 x 1-1/4
hex head cap screws and hex lock nuts.
3-10.4 Connect warning light harnesses to
lights. Note that 2-24" harness extensions
are required at the rear of the main harness
for adequate length.
3-10.5 Attach SMV emblem and mounting
bracket to rear center frame bar using 1/2-13
x 5-1/2 hex head cap screws, 1/4-20 x 3/4
hex head cap screws, and hex lock nuts.
The SMV sign should be centered on the
rear bar of the frame.
3-25