Table of Contents
Advertisement
4-12 DISC GANG ANGLE SETTINGS
4-12.1
Under normal operating conditions, the
gang angles may be set front at 18
o
16
or front at 14
4-10). The more aggressive angles, front at
o
o
18
, rear at 16
due than the less aggressive settings. With
either combination, the gang depth can also
be adjusted to operator preferences of level-
ness and residue coverage.
4-12.2
In certain conditions it is possible to use
different combinations of the gang angles,
but is not recommended.
o
, rear at
o
o
, rear at 12
(See Figure
, will tend to bury more resi-
4-12.3
For most conditions the rear gang depth
should be the same or shallower than the
front gang. To adjust rear gang depth, ex-
tend radius rod to increase depth or retract
radius rod to decrease depth.
IMPORTANT
AFTER ADJUSTMENTS ARE MADE TO REAR
GANGS, CHECK BOTH SIDES TO BE SURE
THEY ARE THE SAME DEPTH. THIS CAN BE
DONE BY MEASURING FROM THE FRAME
DOWN TO THE TOP OF THE BLADES OF
EACH GANG.
4-12.4
The front gangs should not require any
adjustment of the radius rods after they are
initially set (See Figure 3-11)
4-11
Hide quick links:
Advertisement
Table of Contents
