Table of Contents
Advertisement
Auto-Reset Clamp and Shank
Assembly
1. The spring clamp weldments are already located on
the frame at the proper spacing.
2. Attach wearstrip to straight leg shank using wearstrip
bracket, 3/4-10 x 3 hex head cap screw, and 3/4-10
hex lock nut (See Figures 3-2 through 3-4.)
3. Attach steel point to low disturbance straight leg
shank using 1/2 x 2 and 5/16 x 2 spring slotted pins.
Place pins with open ends oriented opposite of each
other.
Figure 3-2: Auto-Reset Clamp and Straight Leg Shank Assembly
ASSEMBLY INSTRUCTIONS
4. Attach top of shank point assembly to front of spring
clamp assembly using 3/4-10 x 4 hex head cap screw
and hex lock nut. Attach lower hole of shank point
assembly to rear of spring clamp assembly using
5/8-11 x 3-3/4 hex head cap screw, connex bushing,
and 5/8-11 hex lock nut.
5. Adjustment holes are provided in the spring clamp
weldment to compensate for varying ground
conditions and depths of operation.
3-3
Advertisement
Table of Contents
