Table of Contents
Advertisement
NOTE: DISC GANG CYLINDER IS FULLY RETRACTED.
16"
disc gang height
11. Connect the front gangs to the radius rods with a 1-8
x 5-1/2 hex head cap screw. Before tightening the
front gangs, adjust the gang height as shown in
Figure 3-16 to 17" from the bottom of the frame to
the top of the disc blades.
12. Once this dimension is set, tighten jam nuts on the
front radius rods.
13. The rear radius rods are adjustable and once
installed with a 1-8 x 5-1/2 hex head cap screw
should be set to 16" from the bottom of the frame to
top of disc blade for initial operation.
Figure 3-16: Disc Gang Height Adjustment
ASSEMBLY INSTRUCTIONS
Auto Reset Shank and Shovel
Installation
1. Attach each shank assembly to each clamp
assembly using 3/4-10 x 5 hex head cap screw in the
top hole, 3/4-10 x 4 hex head cap screw in the
bottom hole, and hex lock nuts.
NOTE
For shallower depths, it may be necessary to move
shank into upper mounting holes. For certain conditions
shank may also be rotated forward.
2. Install 2 x 1 x 18 spike to each shank using 1/2-13 x 3
hex head cap screws, flat washers, and heavy hex
nuts (See Figure 3-15.)
17"
3-19
Advertisement
Table of Contents
