Rear Jack Installation (2210-09 & -11) (Option) - Landoll 2210 Operator's Manual

3-12 REAR JACK INSTALLATION (2210-09 & -11) (OPTION)
A rear jack assembly is available option on the
rear of the 2210-09 & -11 Disc Chisel models. This
is extremely helpful if an attachment has been
added to the rear of the machine for stability.
3-12.1 Attach rear jack mount and rear jack
mount plate weldment to the rear frame of
the Disc Chisel using 5/8-11 x 6 hex head
cap screws and hex lock nuts (See Figure
3-19).
IMPORTANT
THE REAR JACK TUBE SHOULD BE LO-
CATED TO THE REAR OF THE DISC CHISEL
NEAR THE CENTER OF THE FRAME.
3-12.2 Slide rear jack tube into rear jack mount
plate from the bottom and hold in desired lo-
cation with 5/8 detent pin with chain and 3/16
x 1-1/2 cotter pin.
5/8-11 HEX LOCK NUT
REAR JACK MOUNT PLATE
REAR JACK MOUNT
5/8 DETENT PIN
W/ CHAIN
5/8-11 X 6 HEX
HEAD CAP SCREW
REAR JACK TUBE
rear jack inst
Figure 3-19 Rear Jack Installation
REAR
FRAME
3/16 X 1-1/2
COTTER
PIN
3-27