Auto Reset Shank And Shovel Installation - Landoll Weatherproofer III 2310 Series Operator's Manual

ASSEMBLY INSTRUCTIONS
11. Connect the front gangs to the radius rods with a 1-8
x 5-1/2 hex head cap screw. Before tightening the
front gangs, adjust the gang height as shown in
Figure 3-12 to 16" from the bottom of the frame to
the top of the disc blades.
12. Once this dimension is set, tighten jam nuts on the
front radius rods.
13. The rear radius rods are adjustable and once
installed with a 1-8 x 5-1/2 hex head cap screw
should be set to 16" from the bottom of the frame to
top of disc blade for initial operation.
3-16
Figure 3-12: Disc Gang Height Adjustment
Auto Reset Shank and Shovel
Installation
1. Attach a wear guard clamp around wear guard and
shank using 1/2-13 x 2-3/4 hex head cap screw and
hex lock nut (See Figure 3-13.)
2. Attach each shank assembly to each clamp
assembly using 3/4-10 x 4 hex head cap screws and
hex lock nuts.
3. Connect subsoiler points to each shank using 3/8 x 2
spring slotted pins.
F-556-0910 Edition