Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Shank Installation
See Figure 2-2
through
dimensions. Verify that all shank clamps and extensions
are properly installed.
1. Install shanks in clamps
a. Spring clamp assembly - Install shank in clamp
using 5/8 X 1-3/4 round head square neck screw
and flange lock nut provided.
b. Install shank clamp, 1/2 x 3-1/4 hex head cap
screw, and lock nut across bottom of shank
clamp weldment.
c. S-tine clamp assembly - Install shank in S-tine
spring using 5/8 X 2-1/4 bolt and flange lock nut
provided.
2. Install sweep on shank with 7/16 X 1-1/2 plow bolt,
washers, and nuts provided. Note that the flat washer
is only used in the lower slotted sweep hole.
3-24
2-6
for shank placement
See Figure
3-18.
NOTE
Spring shank assemblies with frame extensions (front
bar) are mounted reversed for narrower shipment. These
shanks must be removed and turned forward for proper
operation.
See Figure 2-2
placement. and
See Figure 3-18
shank extension. After shanks have been reversed, verify
that springs have been set to the proper tension. Adjust
the spring until there is 1/8" gap between the top of the
mount and locking jam nut on top of the spring
Figure 3-17
Lock the jam nut against the top of the
spring, not the top of the mount.
NOTE
Refer to
"Spring Shank" on page 4-9
adjustment and operation of spring shanks.
1/8"
Figure 3-17: Spring Adjustment
through
2-6
for proper
for proper u-bolt and
See
for proper
5/8 X 3 BOLT
SPRING PLATE
5/8 JAM NUT
SPRING
ASSEMBLY
SHANK CLAMP
WELDMENT
MAIN PIVOT
BOLT
F-1105-1120
Advertisement
Table of Contents
