Auto-Reset Clamp And Shank Assembly - Landoll 2510 Series Operator's Manual

ASSEMBLY INSTRUCTIONS
5/8-11 X 3-3/4 HEX
HEAD CAP SCREW
3/4-10 X 4 HEX
HEAD CAP SCREW
SPRING CLAMP
ASSEMBLY
3/4-10 X HEX
LOCK NUT
5/8-11 HEX
LOCK NUT
SHANK POINT
ASSEMBLY
SEE DETAIL A
m179964 op
Auto-Reset Clamp and Shank
Assembly
1. The spring clamp weldments are already located on
the frame at the proper spacing.
2. Attach wearstrip to straight leg shank using wearstrip
bracket, 3/4-10 x 3 hex head cap screw, and 3/4-10
hex lock nut(See Figure 3-2.)
3. Attach steel point to straight leg shank using 1/2 x 2
and 5/16 x 2 spring slotted pins. Place pins with open
ends oriented opposite of each other.
3-4
Figure 3-2: Auto-Reset Clamp and Shank Assembly
POINT PIN
PLACEMENT
CONNEX
BUSHING
3/4-10 X 4
HEX HEAD
CAP SCREW
3/4-10 X 3
HEX HEAD
CAP SCREW
5/8-11 X 3-3/4
HEX HEAD
CAP SCREW
5/16 X 2 SPRING
SLOTTED PIN
4. Attach top of shank point assembly to front of spring
clamp assembly using 3/4-10 x 4 hex head cap screw
and hex lock nut. Attach lower hole of shank point
assembly to rear of spring clamp assembly using
5/8-11 x 3-3/4 hex head cap screw, connex bushing,
and 5/8-11 hex lock nut.
5. Adjustment holes are provided in the spring clamp
weldment to compensate for varying ground
conditions.
3/4-10 HEX
LOCK NUT
5/8-11 HEX
LOCK NUT
WEARSTRIP
BRACKET
WEARSTRIP
STEEL
POINT
1/2 X 2 SPRING
SLOTTED PIN
DETAIL A
F-729-0913 Edition