Field Operation; Leveling (Front-To-Rear) - Landoll 2210 Operator's Manual

4-8 FIELD OPERATION

4-8.1 Raise the unit to take the weight off of
the transport locks. Remove the transport
locks from the lift cylinders. Store the trans-
port locks on the retainers above the main lift
(See Figure 4-7).

4-9 LEVELING (FRONT-TO-REAR)

4-9.1 The leveling feature on the Disc Chisel
is used to keep the machine level when rais-
ing the unit from a working position to a
transport position. The leveling feature is
also used to level the unit from front-to-rear
to perform a level operation in the field.
4-9.2 The unit should be level from front to
rear. This will reduce horsepower require-
ments, allow a more uniform tillage opera-
tion, and reduce unnecessary point wear.
4-9.3 To adjust the leveling feature, loosen
jam nuts at each end of the radius rod using
the adjustment wrenches (See Figure 4-8).
To raise the front of the Disc Chisel,
lengthen the radius rod assembly. To lower
the front of the Disc Chisel, shorten the ra-
dius rod assembly. After adjusting, retighten
jam nuts at each end. Adjustments should be
made in small increments.
stored trans lock
Figure 4-7 Stored Transport Locks
HITCH RADIUS
ROD ASSEMBLY
2210 level
Figure 4-8 Radius Rod Leveling Adjustment
1-1/2 X 16 LOCKOUT
CYLINDER STOP
L-PIN
1/8 HAIRPIN
1-1/2 - 6 HEX
JAM NUTS
ADJUSTMENT
WRENCHES
4-7