Landoll 2210 Operator's Manual page 30

3-6.4 Lift front gangs up under frame and in-
stall 1-7/16 x 6-3/8" pin on inner mount with
roll pins (See Figure 3-7).
3-6.5 Attach pivot block and orientate as
shown so the flanges are to the top and bot-
tom. Slide gang from the rear of the outer
gang mounts into the front position.
3-6.6 Install the bushing and 1-8 x 6 hex head
cap screw and hex lock nut at the rear of the
gang mount to secure the gang assembly.
IMPORTANT
MAKE SURE THE HEX LOCK NUT IS LO-
CATED ON TOP OF THE GANG ASSEMBLY.
3-6.7 Install roll pins into the pin, disc angle.
The 4" roll pin will just go through the pin to
act as a handle. The 2" roll pin will be cen-
tered in the pin.
3-14
1" DISC ANGLE PIN
1-7/16 X 6-3/8
PIN
3/8 X 2-1/2
ROLL PIN
1-8 HEX
LOCK NUT
NOTE:
PIVOT BLOCK
ORIENTATION
2210 frt gang
Figure 3-7 Front Disc Gang Installation
3/8 x 4 ROLL
PIN
3/8 X 2 ROLL
PIN
1/4 HAIR PIN
BUSHING
1-8 X 6 HEX
HEAD CAP
SCREW