Assembly Instructions - Landoll 2210 Operator's Manual

ASSEMBLY INSTRUCTIONS

It is very important that your new 2210 Disc
Chisel be properly assembled, adjusted and lubri-
cated before use. Illustrations to assist with the as-
sembly process are provided in Section 2, "Stan-
dard Specifications". They show proper shank
and light mounting bracket spacing. Illustrations in
this section show proper assembly procedures. Re-
move paint from grease fittings. Replace any
grease fittings that are damaged or missing. Be
sure to return screws, clips, etc., to their original lo-
cations.
To insure alignment of assemblies, leave the
nuts loose until completion of final assembly. Use
lock washers or flat washers as specified. Spread
all cotter pins.
After completion of final assembly, tighten
all nuts evenly to prevent misalignment, distortion
or binding. Tighten all screws and nuts to the rec-
ommended torques shown in Table 2-1, "Standard
Bolt Torques".
DANGER
DISC BLADES ARE EXTREMELY
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR DISC
BLADES. DO NOT ALLOW DISC TO
ROLL OVER OR FALL ONTO ANY
BODY PART. DO NOT ALLOW
WRENCHES TO SLIP WHEN WORKING
NEAR DISC BLADES. NEVER PUSH
WRENCHES TOWARD DISC BLADES.
DO NOT CLIMB OVER MACHINE
ABOVE DISC BLADES. FAILURE TO
STAY CLEAR OF DISC BLADE EDGES
CAN CAUSE SERIOUS PERSONAL IN-
JURY OR DEATH.
WARNING
DO NOT ATTEMPT TO LIFT HEAVY
PARTS (SUCH AS THE FRAME, DISC
GANGS, WHEEL LIFT, AND PULL
HITCH) MANUALLY. USE A HOIST OR
A FORKLIFT TO MOVE THESE PARTS
INTO POSITION.
DANGER
TO PREVENT ACCIDENTAL LOWER-
ING:
1. ALL HYDRAULICALLY ELEVATED
EQUIPMENT MUST BE LOCKED OUT
USING THE CYLINDER LOCKOUTS.
2. LOWER EQUIPMENT TO THE
GROUND WHILE SERVICING OR
WHEN IT IS IDLE.
FAILURE TO TAKE MEASURES TO
PREVENT ACCIDENTAL LOWERING
MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH.
CAUTION
BE SURE TO BLEED THE HYDRAULIC
SYSTEM OF ALL AIR IN LINES AFTER
INSTALLATION. FAILURE TO BLEED
THE SYSTEM OF ALL AIR CAN RE-
SULT IN IMPROPER MACHINE OPERA-
TION.
CAUTION
INCORRECT ADJUSTMENT OF DISC
ADJUST RODS WILL CAUSE PERMA-
NENT EQUIPMENT DAMAGE.
3
3-1