Troubleshooting Guide - Landoll 2210 Operator's Manual

TROUBLESHOOTING GUIDE

The Troubleshooting Guide, shown below, is included to help you quickly locate problems that can hap-
pen using your 2210 Disc Chisel. Follow all safety precautions stated in the previous sections when making
any adjustments to your machine.
PROBLEM
UNIT NOT PULLING EVEN
UNEVEN DEPTH
UNIT SIDE DRAFTS OR MOVES SIDE TO SIDE
SHANKS PLUGGING WITH RESIDUE
SHANKS NOT PENETRATING
WHEEL BEARING FAILURE
HYDRAULIC - DISC GANG LIFT CYLINDER
NOT FULLY EXTENDING
HYDRAULIC - ENTIRE UNIT SETTLING
DISC GANG PLUGGING
DISC GANG WILL NOT TURN OR
PUSHES SOIL
PROBABLE CAUSE:SOLUTION
Disc gangs uneven depth: adjust depth/rephase
disc gang cylinders. See "Hydraulic Disc Gang Lift
System" on page 4-6.
Unit not level when under power in the field: level
unit front to rear. See "Leveling (Front To Rear)" on
page 4-6.
Excessive disc gang depth or down pressure:
reduce disc depth.
Tire pressure too low: check inflation.
Unit not level front to rear: adjust unit to be level.
Lift wheels not carrying enough weight: adjust
depth stop and raise implement.
Unit not level front to rear: adjust unit to be level.
Unit not level: level machine. See "Leveling (Front
To Rear)" on page 4-6.
Discs not cutting residue: adjust disc depth.
Unit not level: level unit front to rear. See "Leveling
(Front To Rear)" on page 4-6.
Excessive disc depth: reduce depth
Points worn: install new points.
Triple-lip seals not installed correctly: install seals
with the lips pointing outward away from the hub.
Hoses not properly connected: check hose routing
Depth stop valve not working: repair valve
Operating depth too deep: raise unit.
Conditions too wet: wait until conditions more
favorable.
Depth set too deep for loose or wet conditions:
raise implement or wait until conditions are more
favorable.
Gang bearing failure: replace bearing
5
5-1