Tractor Preparation; Disc Chisel Preparation; Attaching To The Tractor - Landoll 2210 Operator's Manual

4-1 TRACTOR PREPARATION

The Landoll 2210 Disc Chisel is designed to be
pulled by tractor equipped with a double lip or
clevis type hitch. If your tractor is not equipped as
such, you need to purchase the hitch from your lo-
cal tractor dealer. If your Disc Chisel is equipped
with the clevis option, this should be removed. The
clevis option is only for transport use.

4-2 DISC CHISEL PREPARATION

4-2.1 Prior to operating the 2210 Disc Chisel,
inspect it thoroughly for good operating con-
dition.
4-2.2 Replace worn or missing parts.
4-2.3 When the machine is new, check the
bolt tightness after a few hours of operation.
Tighten any loose nuts or bolts. Check the lift
wheel lug bolts daily.
4-2.4 Check the lift wheel tire inflation. Inflate
all tires equally to avoid side draft. Follow the
tire manufacturer's recommended pressures
listed on the sidewall of the tires.
4-2.5 Check disc scrapers for proper adjust-
ment to the disc blade (See Figure 4-1).
4-2.6
Lubricate the machine as shown in Sec-
tion 4-17 (See Figure 4-14).

4-3 ATTACHING TO THE TRACTOR

4-3.1 Align the tractor drawbar with the ma-
chine. Raise or lower the Disc Chisel ring
hitch, as needed, using the swivel jack. At-
tach the unit with proper size hitch pin.
4-3.2 Always place the swivel jack on the inte-
rior mount before setting the machine in mo-
tion.
4-2
Before attaching the Disc Chisel, prepare the
tractor as follows:
4-1.1 Inflate the rear tractor tires equally and
add ballast according to the tractor opera-
tor's manual.
4-1.2 Lock the tractor drawbar in the center
position.
Figure 4-1 Disc Scraper Adjustment
4-3.3 Clean all hydraulic couplings and attach
to the tractor.
4-3.4 Fully extend the hydraulic lift wheel cyl-
inders, and place the cylinder lockouts in the
transport lock position over the cylinder rods.
Secure the lockouts with the lockout pins.