Cursor Auto Mode; No Object - JRC JMR-5410-4X Instruction Manual

3.15 Cursor AUTO Mode

The cursor AUTO mode (referred to as AUTO mode henceforth) is a function that automatically
executes the function (operation) that is assigned to the object when the object under the cursor is
clicked on.
The AUTO mode is effective for the following objects.
Object
No object (when the button is clicked on the
position without a valid object under the AUTO
mode on a chart/PPI)
AIS
TT
(AZ) Acquisition/Activation Zone
AIS filter
User map
EBL
VRM
EBL/VRM intersecting point
PI
Monitoring dragging anchor

3.15.1 No object

When the button is clicked on the position without a valid object under the AUTO mode on a chart/PPI,
the following operation is performed.
Acquires the TT target manually when the button is clicked on inside of the PPI.
Memo
Manual acquisition is not allowed in any of the following cases:
•
Radar antenna standby state
•
Occurrence of PROC (Interrupt 1) / PROC (Interrupt 2) alert
•
Occurrence of target tracking function alert.
•
Occurrence of ship's heading alert.
•
Using at the position further than 32 NM from the own ship's position
•
Using at the position closer than 0.1 NM from the own ship's position
Section that describes the function (operation) to
be executed
3.15.1 No object
3.15.2 AIS
3.15.3 TT
3.15.4 (AZ) Acquisition/Activation Zone
3.15.5 AIS filter
3.15.6 User map
3.15.7 EBL
3.15.8 VRM
3.15.9 EBL/VRM intersecting point
3.15.10 PI, 4.6 Using Parallel Index Lines (Pl)
3.15.11 Monitoring dragging anchor
3-27 Section 3 Common Basic Operations
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B
1