Acq Manual (Manual Acquisition) Mode; Using Manual Acquisition And Auto Acquisition Together - JRC JMR-5410-4X Instruction Manual

6.5.1.2

ACQ manual (manual acquisition) mode

Memo
The manual acquisition mode does not function in the following states.
The number of tracked targets has reached the
maximum count.
The radar antenna is in the standby state.
A PROC (Interrupt) warning is being generated.
A Gyro (I/F)/Gyro (Data)/Heading (Data) warning is being
generated.
The tracked target is located 32 NM away from own ship.
The tracked target is located less than 0.1 NM from own
ship.
To acquire the tracked target in the manual acquisition mode
1
Set the cursor mode to the AUTO mode.
2
Place the cursor on the target to be acquired and then click on.
The target is acquired and the initial acquisition symbol is displayed.
The vector is displayed within 1 minute.
6.5.1.3

Using manual acquisition and AUTO acquisition together

By using manual acquisition with AZ enabled, AUTO acquisition and manual acquisition can be used
together. They may be used if a target to which particular attention should be given is manually
acquired and other targets are automatically acquired.
State
Target manually acquired.
The initial acquisition symbol is displayed.
Target that has passed for 1 min.
The acquisition symbol and vector are displayed.
Action to Take
Erase unnecessary targets.
Start the radar transmission.
Clear the warning.
The manual acquisition mode cannot be
used.
6-19 Section 6 Target Tracking and AIS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27