Adjusting The Bearing; Adjusting A Distance; Radar Operation Modes - JRC JMR-5410-4X Instruction Manual

14.2.1.3 Adjusting the bearing

Adjust the bearing so that the bearing of the target measured by the compass on the ship and the
bearing of the image that is displayed on the radar match.
Memo
This function is disabled in rader interswitch mode.
1
Set the bearing mode to [H UP] on a top screen and set the image processing mode to
[Process Off].
For the bearing mode setting method, refer to "5.4.5 Setting the azimuth mode" and for the
image processing mode setting method, refer to "5.4.4 Using video processing (Echo
Process)".
2
Measure a bearing in the ship's heading direction of a suitable target (for instance,
halted ship, breakwater, and buoy) by using the compass on the ship.
3
Click on the [Bearing Adjustment] input box.
A numeric value input keyboard is displayed.
4
Input an adjustment value in the input box so that the bearing of the target that was
measured in Step 2 indicates a correct bearing. (0 to 359.9°)
For the method of using the numeric value input keyboard, refer to "3.19.2 Name and function
of each section of the keyboard".

14.2.1.4 Adjusting a distance

Adjust the distance of the target on the screen so that the correct distance is displayed.
1
On the radar screen, specify a target whose distance is available in advance.
2
Click on the [Range Adjustment] input box.
A numeric value input keyboard is displayed.
3
Enter an adjustment value in the input box so that the distance of the target specified
in Step 1 indicates the correct distance. (128 to 1024)
For the method of using the numeric value input keyboard, refer to "3.19.2 Name and function
of each section of the keyboard".

14.2.1.5 Radar operation modes

Click on one of the radar operation mode buttons to select either the [Master] mode or the [Slave]
mode.
[Master] : Can control the radar antenna.
[Slave] : Cannot control the radar antenna. The display unit uses the radar signals controlled by the
master radar antenna.
Memo
While in the Slave mode, the operation to control the radar antenna is disabled.
14-3 Section 14 Adjusting and Setting up Equipment (for Services)
1
14