Software Update - JRC JMR-5410-4X Instruction Manual

15.6 Software Update

This section describes software update of this equipment.
Memo
When software update starts, the currently active mode is terminated automatically. Complete the
necessary operations such as the saving of settings prior to the start of update.
[Operation procedure]
Open the Software Update screen by performing the following menu operations.
[Menu] button → Maintenance → Software Update
1
Set the USB memory device containing the update data.
2
Click on the [Software Update] button.
A file selection dialogue appears.
3
From the [Drive] combo box, select the drive where the updating data is stored.
4
Select MR_xx.xx.xxx.exe from the file list.
MR_xx.xx.xxx.exe is displayed in [File Name].
5
Click on the [OK] button.
The update content confirmation dialogue appears.
6
Confirm the contents and click on [OK].
Installation starts and a screen is displayed indicating that installation is being performed.
Wait for some time until the installation is completed.
Memo
This equipment may restart during installation.
At completion of installation, an installation completion screen is displayed.
7
Switch OFF the power supply of this equipment.
8
Restart this equipment.
9
Check that the software version number has been updated on the [Software] tab that is
displayed by selecting menus, [Maintenance] – [System Information].
15-43 Section 15 Maintenance & Inspection
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
23
24
24
26
27