Setting Up The Display Of Range/Bearing Measurement Function - JRC JMR-5410-4X Instruction Manual

11.1.11 Setting up the display of range/bearing
measurement function
When you select [Tools] in the classification pane, the [Tools] dialogue is displayed in the edit pane.
[Operation procedure]
Open the [Tools] dialogue by performing the following menu operations.
[Menu] button → View → Tools
The descriptions of settings are shown in the table below.
Setting Item
Range Rings
(Fixed range rings)
EBL1
EBL2
VRM1
VRM2
PI
(Parallel index line)
Expand Cursor
readout &
EBL/VRM
Operating Time on
PPI
Section 11 Setting up Screen View
Description of Setting
When this item is selected, the range ring display is
enabled.
Selecting this enables to display the EBL1/EBL2
markers.
Selecting this enables to display the VRM1/VRM2
markers.
Enable the display of a parallel index line by selecting
the item and select the parallel index line to be
displayed by selecting the line.
Set an expanded display of cursor information and
EBL/VRM.
On Always expanded for display.
On(5s) Expanded for 5 seconds after the operation.
Off Not expanded.
Display/hide total operating time of display unit and
TX time of scanner on PPI.
11-16
Setting Value
To enable: Select.
To disable: Clear.
To enable: Select.
To disable: Clear.
To enable: Select.
To disable: Clear.
To enable: Select.
To disable: Clear.
Selection of parallel
index line
Index Line1 to 8
On / On(5s) / Off
Shown: Selected
Hidden: Clear