Setting Dgps - JRC JMR-5410-4X Instruction Manual

13.19 Setting DGPS

Set a DGPS receiver.
[Operation procedure]
Open the DGPS receiver setting screen by performing the following menu operations.
[Menu] button → Settings → DGPS
The following table shows the setting items.
Setting Item
Select Station
Frequency
Bit Rate
DGPS Mode
DGPS Status
Send Data
Description of Setting
Set a frequency mode that is used by the beacon
station.
Set a frequency that is used by the beacon station.
This item can be set only when Manual is selected
in station selection.
Set a communication baud rate with a beacon
station.
This item can be set only when Manual is selected
in station selection.
Enable/Disable the DGPS mode.
Displays the DGPS status. The status cannot be
edited.
Frequency: Displays the frequency used.
Bit Rate: Displays the modulation speed.
RSSI: Displays the received signal intensity.
Send the setting contents to the DGPS receiver.
During the transmission, "Sending ..." is
displayed as the status. When the transmission
is successful, "Completed" is displayed. When
the transmission failed, "Not Completed" is
displayed.
13-27 Section 13 Setting up the Operation Mode
Setting Value
AUTO / Manual
275.0 ~ 335.0 kHz
50 / 100 / 200
To enable: Select
To disable: Clear
-
-
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B