Setting Up Transparency Of Echo/Radar Trails; Setting Up The Display Of Tt/Ais Target - JRC JMR-5410-4X Instruction Manual

11.1.5 Setting up transparency of echo/radar
trails
When you select [RADAR] in the classification pane, the [RADAR] dialogue is displayed in the edit
pane.
[Operation procedure]
Open the radar setting screen by performing the following menu operations.
[Menu] button → View → RADAR
The descriptions of settings are shown in the table below.
Setting Item
Transparency of
Echo/Trails
11.1.6

Setting up the display of TT/AIS target

When you select [Target] in the classification pane, the [Target] dialogue is displayed in the edit pane.
Configure the settings for TT/AIS targets.
[Operation procedure]
Open the TT/AIS target setting screen by performing the following menu operations.
[Menu] button → View → Target
TT Symbol
10
TT Target ID
The descriptions of settings are shown in the table below.
Setting Item
CPA Ring (Only
Relative mode)
AIS Symbol
Physical AtoN
Virtual AtoN
Section 11 Setting up Screen View
Description of Setting
Click on the control on the slider and set up
the transparency of echoes/trails.
100
AIS Target ID
Description of Setting
Enable the display of the CPA ring (circle
created by using the CPA limit setting range as
the radius and own ship as the centre)
Selecting this enables to display the AIS
symbol.
When the AIS symbol is selected and this item
is selected, the display of Physical AIS AtoN
symbol is enabled.
When the AIS symbol is selected and this item
is selected, the display of Virtual AIS AtoN
symbol is enabled.
0 to 7
0 = Opaque (Nontransparent)
7 = Transparent
AIS Symbol
11-6
Setting Value
Setting Value
To enable: Select.
To disable: Clear.
To enable: Select.
To disable: Clear.
To enable: Select.
To disable: Clear.
To enable: Select.
To disable: Clear.