Installation Precautions - Polycom RealPresence RMX 1500 Getting Started Manual

Installation Precautions

The RealPresence Collaboration Server 2000 can weigh up to 16.5 kg, and the RealPresence Collaboration Server
4000 can weigh up to 40 kg when all slots are occupied.Two people are required to lift the MCU out of the box and also
when installing it in a rack.
Warning: When handling electronic components, standard anti-static precautions must be
observed
• Wear a grounding strap
• Handle cards by their edges only and do not touch their components or connector pins
• Keep components in anti-static bags when not installed in the RealPresence Collaboration Server.
The following precautions should be followed with regards to installation of the Collaboration Server:
● Use a regulating uninterruptable power supply (UPS) to protect the RealPresence Collaboration
Server from power surges and voltage spikes, to keep your MCU operating in case of a power
failure.The RealPresence Collaboration Server 4000 requires either two DC or three AC power
supply cables, each connected to a power supply.
● Place the RealPresence Collaboration Server on a hard, flat surface such as a desktop or mount it
on 19" rack.
The RealPresence Collaboration Server 4000 can also be mounted on a 23" rack.
● The RealPresence Collaboration Server 4000 has a height of 6U. Ensure this space is available on
the rack.
● The airflow of the RealPresence Collaboration Server 1500/1800 is from front to back. Be sure that
the areas in the front and rear side of the system are clear for proper ventilation.
The airflow of the RealPresence Collaboration Server 2000/4000 is from right to left. Be sure that the
areas in the right and left side of the system are clear for proper ventilation.
Warning: Breaking the seal voids the warranty
The RealPresence Collaboration Server 1800 is a sealed system, breaking the seal and opening the
chassis voids the warranty.
Polycom, Inc.
Prepare for Installation
20