Installation Precautions; Installing The Realpresence Collaboration Server (Rmx) 1500; Unpacking The Realpresence Collaboration Server (Rmx) 1500 - Polycom 1500 Hardware Manual

RealPresence Collaboration Server (RMX) 1500 Hardware Guide
● Install the heaviest components on the bottom of the rack first, and then work up.
● Allow the power supply units to cool before touching them.
● Always keep the rack's trays and card's slots closed when not servicing, to maintain proper cooling.

Installation Precautions

When handling electronic components, standard anti-static precautions must be observed:
• Wear a grounding strap
• Handle cards by their edges only and do not touch their components or connector pins
• Keep components in anti-static bags when not installed in the Collaboration Server (RMX) 1500.
The following precautions should be followed with regards to installation of the Collaboration Server (RMX)
1500:
● Use a regulating uninterruptable power supply (UPS) to protect the Collaboration Server (RMX) 1500
from power surges and voltage spikes, to keep your MCU operating in case of a power failure.
● Place the Collaboration Server (RMX) 1500 on a hard, flat surface such as a desktop or mount it on
19" rack.
● The airflow of the Collaboration Server (RMX) 1500 is from front to back. Be sure that the areas in
the front and rear side of the system are clear for proper ventilation.

Installing the RealPresence Collaboration Server (RMX) 1500

Sealed System! The Collaboration Server (RMX) 1500 is a sealed system, breaking the seal and
opening the RMX chassis VOIDS the WARRANTY!
The following procedures have to be performed to install the Collaboration Server (RMX) 1500 in your site:
● Unpacking the RMX
● Installing the RTM ISDN card on the RMX
● Installing the RMX in a rack or as a standalone
● Connecting the RMX to the power source
● Connecting the network (LAN, IP and ISDN) cables to the RMX

Unpacking the RealPresence Collaboration Server (RMX) 1500

Observe the following procedures when unpacking theCollaboration Server (RMX) 1500.
To unpack and lift the Collaboration Server (RMX) 1500:
1 When you receive the Collaboration Server (RMX) 1500 packing case, inspect the equipment for
damage and verify that the components match the packing slip.
2 Open the top cover of the packing case.
Boxes are placed on the top Stratocell® and contain the following:
Polycom, Inc. 14